QuoteDust Yip awesome news, will give that a go nowby Alter3go - Firmware - Marlin
QuoteDust No error actually posted and no configuration files.... this is the error Arduino is displaying at the end when compiling exit status 1 non-constant condition for static assertion I have attached my configuration.h and the endstop_interrupts.h which the check is referring to. This config file I have attached is based on the A8 example, which I will then adapt for the MKS boardby Alter3go - Firmware - Marlin
QuoteMMcLure Also, ENDSTOP_INTERRUPTS_FEATURE is really not needed at all. By default Marlin only checks physical endstops while homing, and homing moves are blocking, so polling the endstops does not affect performance. The only case where ENDSTOP_INTERRUPTS_FEATURE makes sense is if you also set ENDSTOPS_ALWAYS_ON_DEFAULT. So I would be fine with leaving them commented out with a MKS board wiby Alter3go - Firmware - Marlin
QuoteDust No error actually posted and no configuration files.... Did you change the MOTHERBOARD to BOARD_MKS_GEN_13 in Configuration.h yes, when I was compiling it for the MKS board and changed to the Anet when I tried using the example that comes with Marlin. Like I mentioned, I can load it to the MKS board when I comment out the ENDSTOP_INTERRUPTS_FEATURE without any problemsby Alter3go - Firmware - Marlin
Hi guys, I hope someone can help me. My knowledge with coding is novice level, but I have a fair understanding of how the structure works. I want to install Marlin (Anet A8 version) on my MKS Gen 1.4 with TMC2208 drivers, I got everything working as it should, BUT when compiling I run into this error: #if HAS_Y_MIN #if digitalPinToInterrupt(Y_MIN_PIN) != NOT_AN_INTERRUPT attachIntby Alter3go - Firmware - Marlin