This final gocde that I showed there, is original within CURA 4.6.1, I didn't change anything ... I never touched it.by ZtreKo - Firmware - Marlin
I don't know if you got to see the thingverse project I'm using, but I need you to turn off all my printer via the switch installed at the top of the Z axis, because I don't want my printer to stay on all night, in case my printing finish in the middle of the night, the idea is to turn it off (cooler and lcd) alone, as if I had pressed the ON / OFF button, understand?by ZtreKo - Firmware - Marlin
I use the 5 minute pause to wait for everything to cool down and then move the shaft up to the switch (microswitch) and turn everything off !! I need a wait time before executing the function to raise the Z axisby ZtreKo - Firmware - Marlin
g-code final my Ender3: G91 G1 E-2 F2700 G1 E-2 Z0.2 F240 G1 X5 Y5 F3000 G1 Z10 G90 G1 X0 Y M106 S0 M104 S0 M140 S0 M84 X Y E The command I'm going to use was copied from a Thingverse project: GCODE : G4 S300; G0 Z250; tnksby ZtreKo - Firmware - Marlin
Hello, I'm using Marlin on my Ender3 (mks robin 3ed) and I set up a system for automatic shutdown (Z axis on until the end and activates a microswitch, turning everything off) through the custom GCODE, but every end of printing I have to click on button for the printer to continue, that is, if I don’t click, there’s no use using GCODE pause and then move up the Z axis, because it won’t accept theby ZtreKo - Firmware - Marlin