I just always used arduino. There is nothing saying I cannot switch platforms. Never tried anything else. Ill give your link a try. Thanks!by whospatlaw - Firmware - Marlin
I tried. But failed. I did the following. 1. Downloaded Marlin source in link above. 2. Downloaded configurations folder and copied it into the marlin source under config. 3. Then under the config > examples I copied the configuration.h and configuration_adv.h into the Marlin source and overwrote the .h files that were there. 4. Opened project in arduino and immediately tried to verifyby whospatlaw - Firmware - Marlin
Hi Dust, Thanks! I will give this a try and report back.by whospatlaw - Firmware - Marlin
Hi All, Been trying to get bi-linear bed levelling working with a BLTouch on my Anycubic Chiron. I cannot get it to compile and get the attached error log. I have been able to get the mesh levelling compiled and working though. I downloaded the code here: . UBL also works but takes up too much memory to be usable. Any ideas where I can look to try and fix this? I am relatively a rookie witby whospatlaw - Firmware - Marlin