I am using regular double sided sticky tape and it work fine. Jby Joe90 - Plastic Extruder Working Group
No worries brnrd, I thought you might thinking it was Skienforge. nophead - Thanks for re-factoring the bottom line I was having a little difficulty with it, my math's is a bit out of practice these days. The 3 is due to volumetric expansion, β=3α. If the cross section of the filament didn't change or was not important then I would of just used the linear figures. Since it dose I used volumetriby Joe90 - General Mendel Topics
Thanks for the effort brnrd, but my settings for E-Step are around 8.6 or were untill recently ( now 8.5). This setting produces very tidy parts using Gen6 and Resnapper, electronics and application. Also I'm well within 0.1mm on size ( all 3 axis). Trying most of the wiki equations and the odd ones found on the net with no luck, I decided to give the equation ago myself. The most noticable thby Joe90 - General Mendel Topics
Thanks guys, I have increased my temp to 240ºc which has helped. Also tried the Kapton tape with no luck, however by placing some double sided sticky tape on top of it ( B&Q cheap stuff ) it now works a treat. Still getting a bit of warping but it's good enough to work with for the moment. A heated bed is the way to go I guess for zero warp or close to it? I use Resnapper btw not Skienforgeby Joe90 - General Mendel Topics
Hi all, I have just completed my first build of a mendel but I seam to have a few questions regarding the extruder side of things. Electronics : Gen6 Mendel: Standard Filament: 2.7dia ABS Extruder: Own design, 1:5.8 main gear ratio, 17mm dia pinch wheel, nema17 stepper 1.8º Bed: non heated 5mm Al 1050 plate. all works fine regarding the coldend and from what I can tell the hotend. The extrby Joe90 - General Mendel Topics
Hi, I had the same problem, however I am using the arduino interface rather than command line. Also I'm not trying to backup my settings ( which I never bothered with btw ). The error means the timing of the upload is out of sync with the board expect timing, or something to that effect. The problem is to do with the auto sync not so much the fact I was doing something wrong or setting were inby Joe90 - General Mendel Topics