Huxley seedling hot end
Huxley seedling Hot-end Version 2.0
Release status: working
Description | designed Specificaly for the Huxley seedling.
|
License | |
Author | |
Contributors | |
Based-on | |
Categories | |
CAD Models | |
External Link |
Introduction
I know yet another Hot End Sorry..
This one is designed Specificaly for Huxley seedling.
The requirements.
Keep it simple. 1.7 mm filament. Bowden fillament drive. Low profile to get best print height. The ability to mount it 6mm thick perspex. Interchangable Extruder head. 0.2mmm 0.4mm 0.6mm (Fine, Normal, Draft)
Components:-
1 PCB 1 Heater block. 1 Thermocouple. 1 Threaded bar. 1 Peek insulator. 1 2 pin connector. 1 Heater resisistor. 2 E clips for fitting. 1 PTFE bowden tube 365mm. 1 Interchangable Extruder head.