Sdramps
Release status: working
| Description | Run your RAMPS from SD Card!
|
| License | GPL
|
| Author | |
| Contributors | |
| Based-on | [[]]
|
| Categories | Electronics
|
| CAD Models | |
| External Link |
Contents
Summary
Ever wanted to run your RepRap from SD card? Here is your chance! This RAMPS add-on enables you to print from MicroSD.With RAMPS 1.3 and higher it's easily connected to the RAMPS board. You will require special firmware though.
Where to get it?
Depending on the vendor you can buy SD Ramps as bare PCB, DIY-kit or preassembled.
List of suppliers:
ReprapWorld.Com
Ultimachine
Building your own
Bill of materials
| ID | Name | Type |
|---|---|---|
| PCB | SD RAMPS PCB | PCB |
| C1 | 2.2uF Tantalum 1206 | Capacitor |
| IC1 | 74HC4050 | Level inverter |
| IC2 | MIC5209-3.3YS | Voltage regulator |
| LED1 | LED1206 red | LED |
| R1 | 1kOhm 1206 | Resistor |
| SV1/SV2 | 6x2 stackable header | Header |
| U$1 | MicroSD socket |
