Links Into Hangprinter v3 Build Video

On Dec 13-15, 2017, tobben and Tom made a live stream in 4 parts on Youtube, where they built and debugged a Hangprinter v3. The videos are very long, so this wiki page is created as a "table of contents". Help out and fill in if you watch the videos: Part 1, Part 2, Part 3, Part 4.

Part 1

(1m38s): Start

(2m52s): Start of mover build

(5m24s): Snap mover into place

Part 2

(3h28m12s): "Tell the printer to feed out line"

(3h44m): "Start leveling the mover"

(3h52m1s): "We have six of these Beam Sliders. One on each side gets used for D-line."

(3h54m43s): "Let's bring the print bed in place"

(3h56m20s): "Home position will be vertically below our ceiling unit"

(3h57m24s): Torbjørn uses spirit level on mover

(4h2m30s): Using mover as aiming plumb

(4h4m27s): Drawing marks below mover pivot points

Now going into an hour of measuring this

Explanation on RepRap forums

(4h10m7s): First mover levitation

(4h12m10s): Measure ANCHOR_A_Y and parallelize A anchor

(4h13m27s): "As long as the lines between mover's pivot points and anchor's pivot points are parallel, then we're good"

(4h14m1s): "Let's use the number 230" (cm from anchor to mover). Measuring/deciding ANCHOR_A_Y to be 2300.0 mm.

(4h17m47s): Marking out line that is parallel with y-axis

(4h20m53s): To mark out y-parallel lines, start with going through lineroller