Prusa Mendel experience at Sportvision

Overview

Hi, my name is Tim and along with a few other co-workers here at Sportvision we are building a Prusa Mendel.

I started our build by ordering a set of printed parts from a seller on eBay and a full hardware/electronics kit from mixshop.com.

Here is some great intro information to supplement our build - Building Your Own 3D printer

Frame

I'm currently assembling the frame. Should have it all squared up and tightened by the end of the week.

The pulleys included with the printed parts set don't seem to seat with the belt very well. I'm thinking we should just order some good pulleys and belts from SDP.

We also need to decide if the initial build will use the printed PLA bushings or if we should go straight to LM8UU linear bearings.

Extruder

Cold End

The kits I purchased included all of the plastic parts and hardware for Wade's Geared Extruder

Hot End

The hardware kit from mixshop.com includes parts to build this hot end.

Having read that this simple hot end design can fail rather quickly, I'm tossing around the following ideas:

1. Making a variation of this or this.

2. Getting a groovmount from MakerGear and using the other parts we have.

3. Getting a complete hot end kit from MakerGear or RepRap-USA.

Electronics

RAMPS1.4 electronics are on order and should be here by the end of October.