Pronterface error

Mid way through some prints at random times pronterface seems to crash and I get the following on the pronterface command line. any ideas what might be causing it? I replaced the USB cable with a shielded one with two choke coils on each side but no change.

can you print without monitoring printer? The buffer could be filling up during the short corners of the gear, and the requesting of temp data from controller is probably messing up print. it is not necessary to monitor print thru build.

Yes, I'll give it a try. I have to restart the program after it dies because windows shows it as not responding as well.

jamesdanielv Wrote:
-------------------------------------------------------
> can you print without monitoring printer? The
> buffer could be filling up during the short
> corners of the gear, and the requesting of temp
> data from controller is probably messing up print.
> it is not necessary to monitor print thru build.

It still happens with monitoring turned off. I just got the sdranps in so maybe that's my only solution.

The SDRAMP fixed the problem and I buffer everything in the SD card now so I don't have to worry about it.