Hi!
I recently switched to a 1.75mm nozzle (from GGRF), and I'm about to buy ABS.
My first ABS (3mm) was from Ultimachine. I then bough ABS from Paoparts. Ultimachine ABS was good, but a little bit yellow. The Paoparts ABS was pure white (very nice), but had more shrinkage, and was more brittle (cohesion between layers was not as good as with Ultimachine one).
What ABS do you use? I mainly print very little parts (0.1mm layers), like small gears, or figurines, and also need some strongs parts.
Any advice for a good supplier is welcome.
Frédéric