Stepper Motor to RAMPS 1.4/Arduino Mega 2560

Does anyone know of diagrams on how to connect a stepper motor to the RAMPS 1.4/Arduino Mega 2560? I don't want to build a total RepRap machine but I do plan to use the infrastructure for other purposes. I'm not very good with electronics and I can't seem to find basic drawings on how to connect stepper motors the the RAMPS 1.4. I've been searching the wiki non-stop and can't seem to find anything useful for this task.

Links would be greatly appreciated!

Google is your friend!

---

--------------------------------------------------------
Custom all metal CoreXY
- Duet 2 Wifi w/ PanelDue 7i
- 330mm x 360mm x 500mm
- 750w Silicon heater

Custom Mendel90
(Backup printer - Old reliable!) - Sold

Really not helpful

Edited 1 time(s). Last edit at 11/09/2012 05:08PM by murf83.

That Google link Mogal gave takes you right to the wiring diagram on the wiki.

Alright, here.

---

--------------------------------------------------------
Custom all metal CoreXY
- Duet 2 Wifi w/ PanelDue 7i
- 330mm x 360mm x 500mm
- 750w Silicon heater

Custom Mendel90
(Backup printer - Old reliable!) - Sold

You'll love this. I'm an idiot, and even I could do it : ). Installed arudino software, then upload kliment to it, and use printrun to issue stepper commands using the arrows/bullseye. Best of luck.