All-metal hot ends

Hi guys, I'm looking into getting more involved with printing other materials.

What all-metal hot ends have you guys used, seen, recommend? 1.75mm preferred.

A brief search brings up:
Arcol V4 - My concern is it's strength
E3D - Looks good and is in the UK, but know very little about it
Prusa's - Looks... Long.. There was quite a debate some time ago over the design.

I have seen a couple of others pop up in the for sale section over the past few months, but I'm not looking to take a punt here.

All advice and info is appreciated!

[reprap-fab.org]

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Good find, thanks.

Anybody have any experience with any all-metal hot end - for sale from a reputable source?

Thejollygrimreap on #reprap makes one, not sure of his website.

crispy1 Wrote:
-------------------------------------------------------
> Thejollygrimreap on #reprap makes one, not sure of
> his website.


Great thanks, been a few months since being on IRC, will ping him for details.