Welcome! Log In Create A New Profile

Printrboard to Ramps

new to3Dbob

Printrboard to Ramps
May 09, 2013 09:14PM

Registered: 11 years ago
Posts: 67

Hello,
I have a printer setup currently using a printrboard. I would like to switch to a Ramps board. I have been told that I could simply load the Marlin firmware I've been using onto a Ramps board. Is it that simple or am I missing something. Thank you in advance for any in site.

Bob

Reply Quote

Andrew Smith

Re: Printrboard to Ramps
May 09, 2013 09:18PM

Registered: 13 years ago
Posts: 643

Marlin will need to be reconfigured for the RAMPS, but thats should be a one-line change if you have already have a working configuration.

Reply Quote

new to3Dbob

Re: Printrboard to Ramps
May 09, 2013 09:35PM

Registered: 11 years ago
Posts: 67

I do have a fully working configuration. I presume the change will be in the configuration.h file. Thank you very much! I'm still very new to all this but I am really enjoying it and I attribute much of my success thus far to this forum.

Bob