Multifunctional 3D Printer
Posted by aiorobotics
|
Multifunctional 3D Printer October 03, 2013 12:48AM |
Hi,
We are very soon (24 more hours) finishing up our Kickstarter campaign for the ZEUS! We just wanted to remind you that we would really appreciate any support for the last few hours to make ZEUS a successful project.
We also would like to give you a clear idea about our vision, our concept, and the functionality of our prototype. Therefore, we attached a comparison chart to this post. In this comparison, we put ZEUS side by side with Makerbot Digitizer + Replicator and the two existing multifunctional 3D Printer: Personal Fabricator (FABtotum) and Lionhead (Radiant Fabrication).
Any feedback is appreciated!
Thank you very much!
AIO Robotics Team
Edited 1 time(s). Last edit at 10/03/2013 12:48AM by aiorobotics.
We are very soon (24 more hours) finishing up our Kickstarter campaign for the ZEUS! We just wanted to remind you that we would really appreciate any support for the last few hours to make ZEUS a successful project.
We also would like to give you a clear idea about our vision, our concept, and the functionality of our prototype. Therefore, we attached a comparison chart to this post. In this comparison, we put ZEUS side by side with Makerbot Digitizer + Replicator and the two existing multifunctional 3D Printer: Personal Fabricator (FABtotum) and Lionhead (Radiant Fabrication).
Any feedback is appreciated!
Thank you very much!
AIO Robotics Team
Edited 1 time(s). Last edit at 10/03/2013 12:48AM by aiorobotics.
Sorry, only registered users may post in this forum.