Stepper Motor Ramps Control April 15, 2014 12:59PM |
Registered: 10 years ago Posts: 16 |
Re: Stepper Motor Ramps Control April 15, 2014 01:43PM |
Registered: 10 years ago Posts: 466 |
Re: Stepper Motor Ramps Control April 15, 2014 03:35PM |
Registered: 10 years ago Posts: 16 |
Re: Stepper Motor Ramps Control April 15, 2014 04:29PM |
Registered: 12 years ago Posts: 258 |
Re: Stepper Motor Ramps Control April 15, 2014 07:11PM |
Registered: 10 years ago Posts: 466 |
Quote
UNF3D
Printing PLA .3 mm at 205 with no flucuation in temp during the print. Flow rate is 110. Looks to be laying down really nice etrusion but about 15 to 20% in to the cube print it begins stalling. Are you saying I should unplug the etruder motor from the ramps board and plug the motor in its place? Do I do this when the printer is off then try to run the print? Do I put the etruder motor into the - slot? Sorry we are noobs but give us links and we will put in the effort!
Re: Stepper Motor Ramps Control April 16, 2014 01:09AM |
Registered: 10 years ago Posts: 16 |
Re: Stepper Motor Ramps Control April 16, 2014 03:07AM |
Registered: 10 years ago Posts: 474 |