i3 Rework Help (Mainly With RAMPS 1.4) August 24, 2014 10:10PM |
Registered: 9 years ago Posts: 6 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 02:30AM |
Registered: 9 years ago Posts: 39 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 05:27AM |
Registered: 11 years ago Posts: 1,592 |
Quote
pstock175
Main Questions:
1. Sainsmart endstops are 4 pin (S/G/G/VCC) what should I do to accomodate this onto the 3 pins available on RAMPS 1.4 board?
2. Is it likely that solving the endstop problem will solve more motor problems, or is it another problem entirely? Perhaps the stepper drivers? And with that in mind...
3. How would you recommend testing the stepper drivers to see if they are the problem?
I appreciate any help anyone can provide, and can supply more information/clarification if needed.
Thanks!
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 06:13AM |
Registered: 9 years ago Posts: 376 |
Quote
Y-Moves positively **excitement** but not negatively
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 10:22AM |
Registered: 9 years ago Posts: 6 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 02:39PM |
Registered: 9 years ago Posts: 6 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 25, 2014 02:41PM |
Registered: 10 years ago Posts: 581 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 26, 2014 12:58AM |
Registered: 10 years ago Posts: 477 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 26, 2014 01:49AM |
Registered: 9 years ago Posts: 6 |
Re: i3 Rework Help (Mainly With RAMPS 1.4) August 26, 2014 01:54AM |
Registered: 9 years ago Posts: 6 |