Perimeter to infill transition in slic3r

Hi,

I'm getting good results in recent times with my improved printer. One issue that is now more prominent is how slicer handles the order of infill and perimeters.

Is there a way to force slicer to start a new perimeter where the infill round was finished.

With perfect retraction this wouldn't be such an issue but especially with bowden setups the little drops left over when the head start traveling leaves me a rather dirty and swollen seam where to much material cumulates which is visible on the outside perimeter.
Also its not really efficient the have those moves separated and that they are not concentrated in one straight upwards line.

Any work arounds here?



Edited 1 time(s). Last edit at 11/29/2014 07:28AM by sungod3k.