Hello all,
I have a prusa i3 and I am up to the electronics stage (at the end). I am having some problems. I am using a arduino mega w/ RAMPS 1.4
1. Extruder 0 motor is not working. The motor works, I have checked, the driver works, a A4988 pololu driver, but, no go.
2. The heated bed thermsistor. I have no idea as to why this doesnt work! I plugged the thermsistor in to the T0 port for extruder 1 and it reads fine. Back into T0, dead again.
Thanks,
Beeep22