So long story short, my brother pieced together a reprap kit, and couldnt put it together. I have the kit fully assembled and working. In pronterface I can heat the hotend, and move all the motors in the correct directions. So I am almost there, but I went to buy filament, and I have no idea what to get. I have a J end with a brass tip. It also has the finned body, so It leads my to believe it is an MK-V or MK-IV nozzle, but I am not sure what size opening it has.
Bottom line, have a MK-V J head nozzle and am not sure what size filament to get. Either 1.75 or 3, I am not sure. Should I just bite the bullet and buy both?