Hello guys,
I have been using marlin on ramps 1.4 for years ans i am entirely satisfied, But I got some orthogonality problems on a new printer, and I discovers the M556 G-code to compensate orthogonality issues.
As this command is not supported in Marlin, I want to give Repetier a try.
As I have no Heated bed, I configured my ramps 1.4 as motherboard 35 in marlin, which allows me to have a fan controlled by M106 or M107 code to cool down the printed part wired in D09.
And one plugged in D10, which start when hoend reach 50 degrees, to cool down the heatsink of my hot end.
I would like to keep this to fans this way with repetier, How should I configure Repetier for that?
Thanks for your help
