Welcome! Log In Create A New Profile

Repair/update our Mendel please?

Posted by woolworx

woolworx

Repair/update our Mendel please?
April 24, 2015 05:33AM

Registered: 9 years ago
Posts: 3

We have a Mendel printer which, although generally works fine, needs some realignment along with the new upgrades such as multi colour. Is there anyone with Mendel experience who could take this task on please? Obviously there would need to be some £ in exchange.

Reply Quote

3dkarma

Re: Repair/update our Mendel please?
April 27, 2015 05:24PM

Registered: 10 years ago
Posts: 581

Where are you based? UK, obviously, but where in the UK?

Have the upgrades been installed, or are you looking to have them installed? If you want to get them installed, do you have them to hand?

[3DKarma.com] - suppliers of quality, affordable 3D printer kits and filament for the UK market.

Reply Quote

woolworx

Re: Repair/update our Mendel please?
April 28, 2015 06:45AM

Registered: 9 years ago
Posts: 3

We are in Bridnorth Shropshire and as yet we havn't obtained the upgrades (multi colour etc )

Regards

Reply Quote

3dkarma

Re: Repair/update our Mendel please?
April 28, 2015 04:39PM

Registered: 10 years ago
Posts: 581

It's a bit far away, but I'm happy to be on the end of a Skype call if there's someone there who's handy with a spanner.

[3DKarma.com] - suppliers of quality, affordable 3D printer kits and filament for the UK market.

Reply Quote

woolworx

Re: Repair/update our Mendel please?
April 28, 2015 05:22PM

Registered: 9 years ago
Posts: 3

Thanks for the offer - we were hoping for someone who could give some hands-on with the alignment and upgrade install but if that is not possible then we may take you up on the offer - very many thanks - Woolworx