Extruder stops mid print (and it's not jamming) June 03, 2015 09:02PM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 02:48AM |
Registered: 9 years ago Posts: 5,232 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 05:18AM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 05:24AM |
Registered: 9 years ago Posts: 95 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 05:57AM |
Registered: 10 years ago Posts: 40 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 10:01AM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 04, 2015 10:24AM |
Registered: 9 years ago Posts: 95 |
Quote
swicboi
Hmm..sounds like a wierd problem..It sounds to me like your extruder motor may be overheating...Check the trimpot screw on your extruder stepper driver...If its supplying too much energy it can cause the motor to overheat...usually after a couple hours of use...Another option would be putting a fan on the motor
Re: Extruder stops mid print (and it's not jamming) June 06, 2015 01:09PM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 02:58AM |
Registered: 9 years ago Posts: 5,232 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 03:35AM |
Registered: 10 years ago Posts: 14,672 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 09:09AM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 11:16AM |
Registered: 9 years ago Posts: 5,232 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 02:32PM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 03:19PM |
Registered: 9 years ago Posts: 13 |
Re: Extruder stops mid print (and it's not jamming) June 07, 2015 03:25PM |
Registered: 8 years ago Posts: 12 |
Re: Extruder stops mid print (and it's not jamming) October 25, 2015 07:36AM |
Registered: 8 years ago Posts: 1 |
Re: Extruder stops mid print (and it's not jamming) October 28, 2015 09:24AM |
Registered: 8 years ago Posts: 12 |