hacking a PCB milling machine to become a boot strap July 22, 2010 09:15PM |
Registered: 13 years ago Posts: 4 |
Re: hacking a PCB milling machine to become a boot strap July 23, 2010 04:42AM |
Registered: 13 years ago Posts: 7,616 |
Quote
I plan to keep the 4 pol stepper motors, but replace the complete electronics and also add the opto end stops.
Quote
What I am affraid of are the needed software adjustments for machine calibration. Could such a spindle drive with shaft joints be accurately controlled by the software? I probably would need add some code and compile it again, right?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: hacking a PCB milling machine to become a boot strap July 24, 2010 12:08AM |
Admin Registered: 17 years ago Posts: 1,791 |
Re: hacking a PCB milling machine to become a boot strap July 24, 2010 01:15AM |
Registered: 13 years ago Posts: 4 |
Re: hacking a PCB milling machine to become a boot strap February 27, 2011 03:59PM |
Registered: 13 years ago Posts: 4 |
Re: hacking a PCB milling machine to become a boot strap February 28, 2011 06:58AM |
Registered: 15 years ago Posts: 8 |