Extruder stepper motor clicking. Please help. September 27, 2015 03:27PM |
Registered: 9 years ago Posts: 34 |
Re: Extruder stepper motor clicking. Please help. September 27, 2015 05:33PM |
Registered: 8 years ago Posts: 80 |
Re: Extruder stepper motor clicking. Please help. September 27, 2015 05:56PM |
Registered: 9 years ago Posts: 34 |
Re: Extruder stepper motor clicking. Please help. September 27, 2015 11:40PM |
Registered: 9 years ago Posts: 978 |
Re: Extruder stepper motor clicking. Please help. September 28, 2015 01:28AM |
Registered: 9 years ago Posts: 34 |
Re: Extruder stepper motor clicking. Please help. September 28, 2015 04:37AM |
Registered: 9 years ago Posts: 978 |
Re: Extruder stepper motor clicking. Please help. September 28, 2015 08:56PM |
Registered: 8 years ago Posts: 78 |
Re: Extruder stepper motor clicking. Please help. September 29, 2015 02:58AM |
Registered: 10 years ago Posts: 14,672 |
Re: Extruder stepper motor clicking. Please help. September 29, 2015 08:21AM |
Registered: 8 years ago Posts: 78 |
Quote
dc42
What extruder drive design do you have, and what are the extruder steps/mm?
Re: Extruder stepper motor clicking. Please help. September 29, 2015 11:40PM |
Registered: 9 years ago Posts: 34 |
Re: Extruder stepper motor clicking. Please help. September 30, 2015 07:10AM |
Registered: 8 years ago Posts: 78 |
Quote
jobzombi
I found the fix for my problem....I'm an idiot. I forgot that it was a new ramps set....so I had to increase the current on the pololu. It dawn on me when I was going through my kit and I found the old RAMPS kit. Good thing I kept that too, because tinkering with the shield I shorted it so I pulled out a spare pololu from the old kit. I'm assuming this was what was meant with tension, as it not takes a whole lotta force to make it skip. I could push an extra 20+mm of filament outta the stepper before it skips due to back pressure at the J-head; when cold. Now the issue I am having is possibly Repetier related as I upgraded a few weeks back to Win 10. RH will give me an error that RH closed due to an error, in the middle of a print. Hotend stays on and all so I have to run to reopen and stop it. Might opt to install an sd reader. I'm seeing other fellas, and ladies, are having similar issues with win10.
Re: Extruder stepper motor clicking. Please help. September 30, 2015 04:48PM |
Registered: 8 years ago Posts: 78 |