Delta - Marlin - AutoCalibration / Raise Z Between Probes

3D Printer Experts,

I've got a Kossel mini up and running with Marlin firmware. In an attempt to get it autocalibrated, it's looking as though the Z probe lift between probes needs to come up a bit more, since it's dragging the probe along the glass, and causing all sorts of craptastic fun.

Reading a ton of other forums, it appears I need to target this in configuration.h:

"#define Z_RAISE_BETWEEN_PROBING"

I have this in my Prusa i3, but not in the delta firmware set, and adding it appears to do a lot of nothing.

Would anybody know how I can accomplish getting the Z axis to come up more in between probes on the autocalibration? Thanks.

It sure depends on the Marlin version you are using.
I tried to reduce the "define Z_RAISE_BETWEEN_PROBING on the 1.1dev versions as well as the 1.1 RC versions.

It always worked for me.
-Olaf

It appears I'm horrible in closing my questions out. I very much appreciate the assistance, this solved the issue.