Running stepper motors with encoders with RAMPS April 29, 2016 09:47AM |
Registered: 8 years ago Posts: 44 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 09:55AM |
Registered: 12 years ago Posts: 2,470 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 11:12AM |
Registered: 12 years ago Posts: 1,236 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 11:31AM |
Registered: 8 years ago Posts: 44 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 12:11PM |
Registered: 12 years ago Posts: 2,470 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 12:43PM |
Admin Registered: 16 years ago Posts: 13,906 |
Re: Running stepper motors with encoders with RAMPS April 29, 2016 01:39PM |
Registered: 9 years ago Posts: 483 |
Re: Running stepper motors with encoders with RAMPS April 30, 2016 11:32AM |
Registered: 11 years ago Posts: 564 |
Re: Running stepper motors with encoders with RAMPS April 30, 2016 11:39AM |
Registered: 11 years ago Posts: 564 |
Quote
bobc
The Mod-T printer uses DC motors with encoders, this was mentioned in the ServoLolu thread, but I don't know what electronics is used.
Re: Running stepper motors with encoders with RAMPS April 30, 2016 12:03PM |
Registered: 12 years ago Posts: 1,236 |
Quote
LoboCNC
Quote
bobc
The Mod-T printer uses DC motors with encoders, this was mentioned in the ServoLolu thread, but I don't know what electronics is used.
The MOD-t uses conventional DC motors and encoders rather than closed-loop steppers, and it uses a proprietary controller board and firmware. In the Servolulu thread, I replaced the MOD-t controller board with a Teensylu board and 4 of my Servolulu drivers.
Re: Running stepper motors with encoders with RAMPS April 30, 2016 12:39PM |
Registered: 11 years ago Posts: 564 |