Welcome! Log In Create A New Profile

X and Z veryyyyy close inspection!

Posted by macsoft

Forum List Message List New Topic

macsoft

X and Z veryyyyy close inspection!
March 05, 2011 01:40PM

Registered: 13 years ago
Posts: 96

I got a new inspector. He is very dedicated.
Here it is inspecting the Z and X axis. smiling smiley

i was printing this part to support my plug-n-play electronics box:

Picture15.png

Picture16.png

Picture17.png

tha inspector has approved the print tongue sticking out smiley

Reply Quote

Greg Frost

Re: X and Z veryyyyy close inspection!
March 05, 2011 06:12PM

Registered: 13 years ago
Posts: 486

how do you remove the fur from your prints?

Reply Quote

macsoft

Re: X and Z veryyyyy close inspection!
March 06, 2011 10:37AM

Registered: 13 years ago
Posts: 96

In skeinforge you can do it tunning Retraction in Dimension.
I'm still gcoding with RepSnapper (cant tune all the options on skeinforge to get the same result yet), so i just tune feed rate and and Extruder STU to minimize it.

Reply Quote

brnrd

Re: X and Z veryyyyy close inspection!
March 06, 2011 10:47AM

Registered: 13 years ago
Posts: 1,780

Lol! I think Greg was referring to cat fur. smiling smiley

Reply Quote

macsoft

Re: X and Z veryyyyy close inspection!
March 06, 2011 12:46PM

Registered: 13 years ago
Posts: 96

looooooooool that is waht i get for reading posts 5 min after i'm out of bed smiling smiley

Cat fur gives the part more strenght!
PLA is a bio material, it just got more bio! tongue sticking out smiley