How to print small object on X400 ?
July 02, 2017 03:34PM
Hi to everyone,

I'm a newbie in the 3d printing and I'm trying to print the figure from the picture on X400, varying the print parameters, but no success.
Can anyone more experienced tell me if that is possible at all. Any advices are highly appreciated.
Thank you in advance.
open | download - Capture.PNG (137.2 KB)
Re: How to print small object on X400 ?
July 03, 2017 03:53AM
You might have more luck turning the object 45 degrees to the z plane with custom support and printing it. As it is orientated you have little contact area, and a lot of bridges.

Simon Khoury

Co-founder of [] Accurate, repeatable, versatile Z-Probes
Sorry, only registered users may post in this forum.

Click here to login