printer halted kill called() after z axis homing

hi friends

after running printer and homing z axis
this error is shown
printer halted kill called()
what should i do?

i using the rumba board

Edited 2 time(s). Last edit at 12/13/2018 05:45AM by mohammad.ak.

It appears that you have a defective end-stop. Re-check the sending a M119 while activating/deactivating the end-stops.

[github.com]

---

Computer Programmer / Electronics Technician

thanks roberts for your answer

but I have three endstop in x,y And z axis and

I checked them with send M119 in activating/deactivate modes

They do Their duty correctly

check your thermistor are reading room temperature

I use a 100k resistor instead of a thermistor and it display the room temprature


and I should say
I do not use heat bed and its thermistor

can you list either the output from the printer, or post your config file?

it is possible that thermistor has electrical issues such as bad wiring and movement causes a misread,

and this will trigger printer to kill function for safety to prevent a nozzle overheating.

of course seeing output log from printer responses will help more, as well as looking at config settings.

i'm sure someone here will help you!

That is a good tip whether or not it solves the problem here.