G'Day Gang,
Is it possible to change the origin from left front to right rear in Cura slicer?
Not a big issue to work around but would be handy if it is possible.
TIA

Edited 1 time(s). Last edit at 12/10/2019 01:25AM by curnowdj.

I have the same issue with my Delta printers. Cura works fine for my homebrew MendelMax, but in the Delta profile my prints are rotated 180° while my motors are wired correctly according to the diagrams I have seen online.

---

http://www.marinusdebeer.nl/