Hi,
How do i Connect a KS0108 controller based full graphic LCD to RAMPS board and configure the Marlin firmware to make it work.
The LCD which i am referring to is this one in the link [
www.jhdlcd.com.cn]
This is the Data sheet : [
www.jhdlcd.com.cn]
I have removed the LCD from the
Rep rap Full Graphics Smart Controller (RFGSC) and extended the pins with a 20 pin JST connector so that i can mount the display on the printer frame and access the SD card externally.
The setup worked for a few days but i accidentally fried the LCD along with all other drivers by placing one of the A4988 Stepper driver wrongly.
I immediately replaced all the Stepper drivers and purchased a new LCD and found out that i got a KS0108 Type LCD insted of the stock ST7920 (the shopkeeper didnt accept a return or replacement).
Thus i am now left with one choise of interfacing KS0108 LCD to Ramps board (more specifically through the 20 pin JST cable that i have extended from RFGSC as shown in the attachment)
Please Help.
Thank you