Hello everyone ,
I've tried to follow this guide:
[
www.longer3d.com]
But when I reach the point that says "
Send M851 Z0 to reset Z offset value"
I just receive:
>>> M851 Z0
SENDING:M851 Z0
echo:Unknown command: "M851 Z0"
I've checked the cable wiring five times and the 3D touch protrude twice when I turn it on and then stays with red light on afterwards - dont know if thats good or bad?
Here's a little info:
echo:Marlin 0.4.0T005-Marlin2.x
echo: Last Updated: 2021-12-28 | Author: Longer3D, Hobi, tpruvot
echo:Compiled: May 5 2022
echo: Free Memory: 2836 PlannerBufferBytes: 1200
Can anyone help me?