Machine working nice - Thanks reprappers!

Hello reprappers,

Instead of just enjoying the success myself I thought I should do it with the community since all of you helped so much to improve my machine.

I was at the point of throwing this out and shoving some money into purchasing an UP, but its working now with your help!

see the video: [vimeo.com]

See the results: [omemon.com]

Thanks again. Please forgive me for always talking bad about techzonecom huxley kit. I don't like people who complain either. I just wanted to let people know about the kits condition.


Owais
www.omemon.com

Edited 1 time(s). Last edit at 07/09/2011 09:19AM by owism8.

looks like you could play with your skeinforge settings some more.

try lower the layer height to 0.25 and play with the width over height ratio.

lower width overheight ratio, lower layer height, lower temp and speed, have allowd me to print better overhangs, of course they all have their limits. Good luck and congrats.