I am at the testing phase with my Prusa and pretty much calibrating and printing "air parts." When I use pronterface "printer interface" it seem to always position the part on the right rear quadrant of the print bed. Is there a way to tell the program to center the part on the bed?

Thank you in advance.

Roy

change your skeinforge or sfact settings to enable "raft", and then look at the other settings on that tab. :-)

You use the Multiply plugin - Activate it and set center x,y at 100,100.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse