reprap.me stepsticks and Gen7 ? September 28, 2012 12:24PM |
Registered: 11 years ago Posts: 273 |
Re: reprap.me stepsticks and Gen7 ? September 28, 2012 03:30PM |
Registered: 11 years ago Posts: 273 |
Re: reprap.me stepsticks and Gen7 ? September 29, 2012 05:36AM |
Registered: 13 years ago Posts: 7,616 |
Quote
The differnce I found is that RAMPS and Sanguinololu use Pull-Down on MS1 and GEN7 has only Pull-Up.
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: reprap.me stepsticks and Gen7 ? September 30, 2012 05:30AM |
Registered: 12 years ago Posts: 1,236 |
Re: reprap.me stepsticks and Gen7 ? September 30, 2012 07:37AM |
Registered: 11 years ago Posts: 273 |
Re: reprap.me stepsticks and Gen7 ? September 30, 2012 07:45AM |
Registered: 13 years ago Posts: 7,616 |
Quote
Is there any way in teacup to reduce the step frequency ?
Quote
Does the timing match the requirements ?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: reprap.me stepsticks and Gen7 ? September 30, 2012 09:11AM |
Registered: 11 years ago Posts: 273 |
Re: reprap.me stepsticks and Gen7 ? September 30, 2012 02:19PM |
Registered: 13 years ago Posts: 7,616 |
Quote
there is some diffence obviously how Teacup drives the motors differnt than Repetier does
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: reprap.me stepsticks and Gen7 ? October 02, 2012 04:56PM |
Registered: 12 years ago Posts: 1,236 |
Re: reprap.me stepsticks and Gen7 ? October 10, 2012 01:47PM |
Registered: 11 years ago Posts: 273 |
Re: reprap.me stepsticks and Gen7 ? April 10, 2014 08:56AM |
Registered: 11 years ago Posts: 25 |
Quote
Traumflug
That's true, Gen7 hardwires MS1 to high to save a resistor and a jumper.