Welcome! Log In Create A New Profile

Advanced

Noise suppressor board

Posted by MotorAssist 
Forum List Message List New Topic
MotorAssist
Noise suppressor board
September 07, 2009 10:11AM
I'm looking forward to being able to complete a step without having to ask a question - wonder when(/if) that will be?

The screw terminal on the noise suppressor board has 2 legs to solder, but also it contacts 2 other pads on the board - are these supposed to be soldered as well, or can I just solder the leads?

Hazel.
Reply Quote
sam0737
Re: Noise suppressor board
September 07, 2009 11:52AM
I don't think you have to. It's just a spare holes that in case someone wants to use a jumper instead of screw terminal.

It doesn't hurt if have them accidentally soldered, no worry.
Reply Quote
MotorAssist
Re: Noise suppressor board
September 07, 2009 12:42PM
Thanks, I shall just do the legs, then.
Also, how on earth do you get the motor tabs soldered? Are they supposed to be right up against one edge of their holes?
Reply Quote
sam0737
Re: Noise suppressor board
September 07, 2009 03:54PM
I don't have a GM3 nor that suppression board...from the photo in the Wiki, I think it will be just exactly what it says - melt a whole lot of solder into the hole will do the job.

Lining it up to the edge might it works easier, but be sure not the break the tabs by bending too much smiling smiley

Edited 1 time(s). Last edit at 09/07/2009 03:54PM by sam0737.
Reply Quote
MotorAssist
Re: Noise suppressor board
September 07, 2009 05:59PM
Done. Thank you.

Hazel

[copycatbot.blogspot.com]
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login