Welcome! Log In Create A New Profile


Wiring to be used for RepRap

Posted by Requiem 
Wiring to be used for RepRap
May 04, 2010 04:35PM

I have been looking for more information on the types of wiring to connect the Stepper board, mother board and Extruder Controller other than the one listed here.

I understand that a 12V power supply of at least 5A is required but as for the wires, like the one between the extruder and the motherboard, what current should the wires be able to carry? Or do I have to specifically buy wire that is able to carry 5-8 ampere of current?


Sorry, only registered users may post in this forum.

Click here to login