Welcome! Log In Create A New Profile


motors not responding

Posted by chernobill123 
motors not responding
February 02, 2015 11:35AM
Hello guys, i have a problem with my reprap, i have marlin firmware, amd i'm using pronderface. the printer is ready, when i 'm testing it to pronterface if i send a command to movr one motor it's moving ok, but after that if i command to move another motor it's not responig, so i must reset the arduino to send another command. Do you have any idea for the problem??? please help, it's for a project for the univerisy//

Edited 1 time(s). Last edit at 02/02/2015 12:41PM by chernobill123.
Re: motors not responding
February 04, 2015 02:36AM
Have you configured the firmware for your set-up?

Waitaki 3D Printer
Sorry, only registered users may post in this forum.

Click here to login