Welcome! Log In Create A New Profile

PCB Design opportunities

Posted by SPR

Forum List Message List New Topic

SPR

PCB Design opportunities
July 23, 2010 06:26AM

Registered: 15 years ago
Posts: 1

Hi All,

I'm looking for PCB design opertunities. Any body need PCB design requirement pls do let me know.

SPR

Reply Quote

peer

Re: PCB Design opportunities
July 26, 2010 11:45AM

Registered: 15 years ago
Posts: 833

You could design a single board RepRap controller, comprising the controlling AVR and all needed stepper drivers and so on.

If it were single-sided, that would help self-fabbers of the PCB.

It would probably be a nice addition to the project and cut costs.

Reply Quote

Mehdi

Re: PCB Design opportunities
August 10, 2010 12:04AM

Registered: 16 years ago
Posts: 5

Hi,

I need a single-side PCB because the double-side PCB need a connection between two sides. And that is very hard to find someone in Tabriz (My hometown in Iran) to do that. Here say "Metalizing" for connecting two side of PCB throw holes.

Regards, Mehdi

Reply Quote

Traumflug

Re: PCB Design opportunities
August 10, 2010 04:37AM

Registered: 15 years ago
Posts: 7,616

Single-sided versions of RepRap electronics exist already: [www.thingiverse.com]

Some of the Pololu electronics designs are single-sided or don't require vias either: [reprap.org]

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Reply Quote

hardness

Re: PCB Design opportunities
August 11, 2010 02:44PM

Registered: 17 years ago
Posts: 11

//You could design a single board RepRap controller, comprising the controlling AVR and all needed stepper drivers and so on.
If it were single-sided, that would help self-fabbers of the PCB.
It would probably be a nice addition to the project and cut costs.//

I'd like to throw my vote in for this one!