Arduino IDE program for dual nozzle February 03, 2016 09:55PM |
Registered: 8 years ago Posts: 25 |
Re: Arduino IDE program for dual nozzle February 04, 2016 03:27AM |
Admin Registered: 16 years ago Posts: 13,906 |
Re: Arduino IDE program for dual nozzle February 04, 2016 03:41AM |
Admin Registered: 16 years ago Posts: 13,906 |
Quote
// This defines the number of extruders
// :[1,2,3,4]
#define EXTRUDERS 2
Re: Arduino IDE program for dual nozzle February 04, 2016 08:43AM |
Registered: 9 years ago Posts: 1,159 |
Quote
VDX
... I'm using Pronterface on the PC and Marlin4Due as firmware on the ArduinoDue - here for 2 or more extruders (or dispensers) I have to change the number in the Marlin4Due firmware in "Configuration.h", line 80
Quote
// This defines the number of extruders
// :[1,2,3,4]
#define EXTRUDERS 2
... and in Pronterface too:
[attachment 71640 Pronterface-Extruders.jpg]
Re: Arduino IDE program for dual nozzle February 04, 2016 10:02AM |
Admin Registered: 16 years ago Posts: 13,906 |
Re: Arduino IDE program for dual nozzle February 04, 2016 10:27AM |
Registered: 9 years ago Posts: 1,159 |
Quote
VDX
... no, I'm using Marlin4Due on RADDS boards - this was only meant as example for the firmware-modification and to clarify the concept of firmware/software-combos.
In original Marlin the extruder count is defined too in "Configuration.h", but line 58 instead of 80 ...
Re: Arduino IDE program for dual nozzle February 05, 2016 01:52AM |
Registered: 8 years ago Posts: 25 |