I just buy few days ago RADDS 1.6 arduino due RADDS lcd 20x4 char
core xy
x, y z, are controlled by 2DM542 with nema 23 , so I took from board only EN , STEP, DIR and GND, increasing high_delay 5, and double_step_delay 2
extruder is controlled by A4988 , is an 0,9 degree from E3D
I try to put repetier 1.0.2 but without success
Problems:
1. After few rewrite firmware LCD begin to show me only strange characters
2. extruder not spinning , no sound like working, nothing ....
3, extruder temp T0 is working (104GT-2) , but bed temp every T1, T2, T3, T4 show me 4 degree fix, I use table temp 0 but without success for EPCOS.
I try to change epcos with another 104GT-2 only for testing and temp become -22 degree also not increasing or decreasing
4. endstop checked with M119 are ok
i saw on youtoube somebody check servomotors in configuration but i don't have something like this
or maybe my arduino due to come with defects ?
any suggestions ?
Edited 2 time(s). Last edit at 07/15/2018 10:55AM by sz3bbylA.