Proxxon Tool Holder PCB MIlling September 02, 2011 04:51AM |
Registered: 13 years ago Posts: 43 |
Re: Proxxon Tool Holder PCB MIlling September 02, 2011 05:47AM |
Admin Registered: 16 years ago Posts: 13,890 |
Re: Proxxon Tool Holder PCB MIlling September 02, 2011 10:53AM |
Registered: 13 years ago Posts: 43 |
Re: Proxxon Tool Holder PCB MIlling September 03, 2011 06:20AM |
Registered: 13 years ago Posts: 7,616 |
Quote
Reading through the RepRap Wiki somebody has definately made one:
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Proxxon Tool Holder PCB MIlling September 04, 2011 05:39AM |
Registered: 13 years ago Posts: 43 |
Re: Proxxon Tool Holder PCB MIlling September 05, 2011 03:30AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Proxxon Tool Holder PCB MIlling September 12, 2011 01:03AM |
Registered: 14 years ago Posts: 573 |
Re: Proxxon Tool Holder PCB MIlling May 31, 2012 04:16AM |
Registered: 12 years ago Posts: 19 |
Re: Proxxon Tool Holder PCB MIlling May 31, 2012 05:50AM |
Admin Registered: 16 years ago Posts: 13,890 |
Re: Proxxon Tool Holder PCB MIlling May 31, 2012 07:47AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Proxxon Tool Holder PCB MIlling September 01, 2012 07:52PM |
Registered: 11 years ago Posts: 369 |
Re: Proxxon Tool Holder PCB MIlling September 02, 2012 04:08PM |
Admin Registered: 16 years ago Posts: 13,890 |
Re: Proxxon Tool Holder PCB MIlling September 03, 2012 03:56AM |
Registered: 13 years ago Posts: 7,616 |
Quote
may i know what kind of software combi u use to "convert" circuit to tracks or is that what to call it?
comes with an G-code exporter which makes excellent drill files and reasonable isolation-mill files. Make sure to get the latest git sources, as this exporter received a lot of attention the last few weeks.Quote
http://pcb.geda-project.org/
gEDA/PCB
Quote
must the bath need to be absolutely soapy? or just water will do?
Quote
the part where the bed zeros, have you tried to just have a light springed wire touch the smooth part of the drill bit?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |