I had my delta Printer working with the arduino ramp set to 8 micro steps. I printed many parts with good
success . Then I thought why not get better resolution and change it to 16 microsteps. I changed the Marlin
config H file to the new steps per unit changed the ramp to 16 micro steps. The machine homes the same except it is smother a good thing.
It prints the parts the correct size as before but the prints are not completing I am getting a lot of skips in the
extrusion the build time is very very slow now. Even if I run the same parts as before they do not
come out nearly as good as before. I must have been luck to have started with the steppers set to 8
micro stepps other wise I would have really be pulling out my hair. But what has change or needs to be adjusted
to let me use 16 micro steps??
Ron