.
sorry problem is solved!
and also here an explanation,
it was not due to the lack of SD card!
there was a mistake, I had not seen this error. (I've read over it)
there was a short circuit in the temperature sensor and therefore it did not start.
.
My first print:
[
www.mijnalbum.nl]
nice .... funny! ;-)
it is still not perfect but I am already very happy with it!
anyone can see the pictures tell about what's wrong?
.
and yes there is something wrong I know,
the hotend is skewed after I change... rebuilt it
I previously had a different, and I think older system!
Here some pictures for remodeling:
[
www.mijnalbum.nl]
[
www.mijnalbum.nl]
[
www.mijnalbum.nl]
[
www.mijnalbum.nl]
after rebuilt:
[
www.mijnalbum.nl]
[
www.mijnalbum.nl]
[
www.mijnalbum.nl]
the problem was that the hotend had to be slid sideways from the cold end.
Now I can push the hotend straight up from underneath there stabbing in.
and because it hotend was stalled, I could not push the hotend out the coldend.
I had to push it with a knife. (not nice) I almost wrecked it!
and hence thus the upstanding edge cut away.
(I hope it was a bit readable!?)
Friendly greetings all!
Rob.