Welcome!
Log In
Create A New Profile
Home
>
Firmware Folder
>
Firmware - mainstream and related support
> Topic
Advanced
Does Marlin support 0.9 deg steppers ?
Posted by
tolisn
Forum List
Message List
New Topic
tolisn
Does Marlin support 0.9 deg steppers ?
July 15, 2015 01:06AM
Registered: 9 years ago
Posts: 25
Hi
Does Marlin firmware support the use for 0.9deg steppers ? What parameters must be changed to install these ?
The road is long but we are getting there.
Reply
Quote
Wurstnase
Re: Does Marlin support 0.9 deg steppers ?
July 15, 2015 01:19AM
Registered: 9 years ago
Posts: 4,977
Sure, just double your steps/mm for those axis.
Triffid Hunter's Calibration Guide
--> X <-- Drill for new Monitor
Most important Gcode.
Reply
Quote
tolisn
Re: Does Marlin support 0.9 deg steppers ?
July 15, 2015 01:36AM
Registered: 9 years ago
Posts: 25
Thanks for your quick reply
Where is this setting located in the marlin files ?
Do I also have to change the microstepping? currently my drivers are set to 1/32 stepping ?
The road is long but we are getting there.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login