Hi folks,
with the help from Olaf, I bumped off most probs but this one has appeared
again. I have three makerbot clone endstops x min, y min, and z max, the red ones
from eBay. If I movethe extruder away, when turned off, and then issue a autohome
through the 12864 lcd everything works.
If I manually issue a move that sends the extruder into the x min endstop, it doesn't
stop. If I manually trigger the x min endstop whilst the extruder is moving to x min, it
doesn't stop.
Oh, z max endstop works and I haven't checked the y min yet.
Any ideas?
Many thanks,
Andrew