Welcome! Log In Create A New Profile

No comms after firmware upload Gen3

Konstraxtor

No comms after firmware upload Gen3
September 17, 2011 04:47AM

Registered: 12 years ago
Posts: 4

In my Mendel Gen3 Electronics I stuk in the building process testing the electronics.
[reprap.org]

After uploading I dont get any comms in the Host Software.
I tried lot's of things but nothing worked.

Can anyone help me?

Reply Quote

Traumflug

Re: No comms after firmware upload Gen3
September 18, 2011 04:40AM

Registered: 13 years ago
Posts: 7,616

Which Firmware are you using? For Gen3, Teacup is currently the best choice, probably. Requires uploading firmware to both, the main board and the extruder controller.

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Reply Quote

Konstraxtor

Re: No comms after firmware upload Gen3
September 22, 2011 02:58PM

Registered: 12 years ago
Posts: 4

I was "using" the FiveD. And now i also tried the teacup, but it didn't help.
I've never had a sign that my uploaded Firmware wants to communicate with my computer...

Reply Quote

Traumflug

Re: No comms after firmware upload Gen3
September 23, 2011 05:50AM

Registered: 13 years ago
Posts: 7,616

Try with one of the examples coming with the Arduino IDE. About everything working on an Arduino works on a Gen3 as well.

If that still doesn't work, you should describe what you're doing and what the actual results are. Reprappers are no clairvoyants.

Generation 7 Electronics	Teacup Firmware	RepRap DIY