British theme - Prusa Mendel

Hello,

I have just posted up a new Prusa machine on my Blog, maybe worth a look if you are just about to build a machine, you may get a few Ideas -





Blog post Here

Cheers,

Rich.

---

[richrap.blogspot.com]

Very nice!

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Thanks Bob, It was a very fun build.

---

[richrap.blogspot.com]

How long did it take you ? Must have been a lot of work to join all those filaments portions together !

Very british

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

DeuxVis Wrote:
-------------------------------------------------------
> How long did it take you ? Must have been a lot of
> work to join all those filaments portions together !

It was done all as complete build plates of parts, so the sections are actually quite long, it was more work, but why not, it's all good fun.
The actual printing was quite quick, done over 2 days at 80mm/sec print speed.
The design was a few days work and assembly was the biggest job.

---

[richrap.blogspot.com]

Now you just have to film that nice machine printing a teapot

(Sorry for the cliché, couldn't resist)

You might be able to make it a bit cheaper if you print it in red with a few yellow stars =D

chrissketch Wrote:
-------------------------------------------------------
> You might be able to make it a bit cheaper if you
> print it in red with a few yellow stars =D


LOL!!!

---

Follow my Mendel Prusa build here: [julianh72.blogspot.com]