I am having a problem with my Y-axis where in printrun, if I am telling it to go up for a while it will suddenly reverse and go down, then go down for a while and suddenly reverse and go up. I am only telling it to move in one direction but it seems to oscillate on its own.

It is a mendel RAMPS 1.4 and using sprinter firmware.

Perhaps the dir line to the driver is floating, i.e. not connected somewhere between the Arduino and the Pololu.

---

[www.hydraraptor.blogspot.com]

Hey thanks for the suggestion! I really appreciate it.

I tested all the pins with a multimeter and they seem solid all the way from the top of the stepper driver to the bottom of the arduino.

Is there anything else that can cause this? Unfortunately I really don't even know what is happening on a technical level. I was hoping it was just some bug in printrun.



** Edit : I resoldered the connections and the problem is gone now. Thanks a lot !

Edited 1 time(s). Last edit at 06/06/2012 04:53PM by Izadien.