Welcome! Log In Create A New Profile

Advanced

Z-axis force down nut.

Posted by below_cho 
Forum List Message List New Topic
below_cho
Z-axis force down nut.
October 11, 2012 09:35PM
Did you found that the Z-axis doesn't in line with the real Z- value when going down?

You can try this: [www.thingiverse.com]
Reply Quote
Scrachbuilder
Re: Z-axis force down nut.
October 13, 2012 06:42PM
Try setting all your zeros with the table down, and all measurements will
have reference to that point - just be sure that side of the frame is true
vertical and ay 90 degrees to keep x and Y axis references true too.
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login